Waxoyl Professional 120-4 is water-repellent and has high-performance inhibitors to give lasting protection from rust. Good penetration makes sure even hard-to-reach places are easy to cover. Protection against corrosion, from the inside out.
One application protects for the life of the vehicle.
Where surface rust already exists, Waxoyl Professional 120-4 stops further corrosion.
"Fogs" the cavities to prove total coverage.
Penetrates deep into seems, providing protection where it is needed most.
Professional application tools snake through existing drains for complete protection without drilling access holes.
Displaces moisture to achieve an optimum bond, even in damp environments. Can be applied to wet surfaces.
A little goes a long way! Optimal protection with only .04 to .05 mm dry film thickness, resulting in a coverage area over 60ft square feet per litre.
Temperature range of active protection from -40°F to 300°F.
Safe on all paint finishes. Contains no silicones or fluorocarbons.
Tech Tips
Apply Waxoyl Professional 120-4 BEFORE applying Hardwax.
Optimal product temperature for application is 70 F. Do not apply product at less than 59 F. Optimal ambient temperatures for application are between 41 F and 104 F. Tins and aerosols can be heated in a bucket of hot water.
Shake 5-liter tins and Aerosol cans well. 58 Liter drums can be mixed, by blowing air using the HRS Gun and the long wand.
If the product is not easy to shake and does not pour smoothly into the guns it is not warm enough! Warm before pouring into the gun.
Apply using approximately 100 PSI for fogging cavities. For surface application use 60 PSI. Pressure can be adjusted slightly to compensate for the products viscosity which is determined by temperature, i.e. if the product is hot you may find it is wise turn the pressure down slightly for material economy.
Product dries clear, however if applied too thickly it appears pink and can attract dirt. Optimal performance can be achieved with only 60 NM film thickness, so for material economy purposes and cleanliness it is wise to not over apply.
If necessary prepare underbody prior to application (see movie below).
Read the General Application Manual well. Contact us for an electronic or a spiral bound paper copy. Watch the application movie below. Pay attention to the duration of spray in the panels, when the trigger is depressed it is typically fully depressed. There is a fine line between a proper thorough application and over applying the product which is wasteful and can leave the cabin of the vehicle smelling for a long time as the solvent slowly evaporates from puddles in the cavities.
